July 28, 2020
I am building a 3D scanner with a laser distance sensor to produce a point cloud representation of the surrounding area. I'll be using an Arduino.
Mathlab can definitely produce a point cloud representation. But I am not sure I can send the raw data to thingspeak at once.
My idea was to collect all the data from the surrounding area and then send it at once to thingspeak. I would be updating the data every minute.
Then I would use Mathlab to convert the raw data in a 3D point representation.
Could I do that with thingspeak?
Any idea would be much appreciated.
November 2, 2020
Do you have an Arduino with network connectivity either onboard or with a shield? Note that maximum update rate to ThingSpeak is 1/15sec. And you'll need to configure the myChannelNumber and myWriteAPIKey variables for your ThingSpeak channel (see https://theessayservice.org).
Most Users Ever Online: 166
Currently Browsing this Page:
Guest Posters: 1
Newest Members:kusmumichael, petersmith99, Rambant, blakeharriss09, optisol, Niyonzima Fils
Moderators: cstapels: 460
Administrators: Hans: 405, lee: 457