allow REACT to act on value in/outside band | General | Forum

The ThingSpeak community site has been upgraded to a new site. This site is currently in read-only mode. You can ask questions or post and read discussions on the new site.

Lost password?
Advanced Search

— Forum Scope —

— Match —

— Forum Options —

Minimum search word length is 3 characters - maximum search word length is 84 characters

sp_Feed sp_TopicIcon
allow REACT to act on value in/outside band
No permission to create posts
May 20, 2013
1:04 am

Forum Posts: 37
Member Since:
December 10, 2012
sp_UserOfflineSmall Offline


As a feature request I would like to see the option to use REACT to act on a value when its outside a given bandwidth.
As an example: when you measure temperatures in a greenhouse you want to know when its getting too cold or when its getting too warm. All other temperatures are OK. For this a user would need to specify a higher limit and a lower limit so the system can signal accordingly.
Currently this can only be achieved by setting 2 separate reacts for the same variable, one checking if the value is below a lower limit and one checking if its above a higher limit.

This setup could then also be used (I hope) to do the opposite, so get a message when the temperature is OK and inside the band. Currently that is not at all possible.


Forum Timezone: America/New_York

Most Users Ever Online: 166

Currently Online:
35 Guest(s)

Currently Browsing this Page:
1 Guest(s)

Top Posters:

rw950431: 272

Vinod: 240

piajola: 95

turgo: 70

vespapierre: 63

Adarsh_Murthy: 62

Member Stats:

Guest Posters: 1

Members: 8665

Moderators: 1

Admins: 2

Forum Stats:

Groups: 3

Forums: 14

Topics: 1600

Posts: 5760

Newest Members:

kusmumichael, petersmith99, Rambant, blakeharriss09, optisol, Niyonzima Fils

Moderators: cstapels: 460

Administrators: Hans: 405, lee: 457